Electromagnetic Compatibility (EMC) /

LISN

Line Impedance Stabilisation Networks (LISNs) are used to measure conducted emissions on power lines. The LISN draws power from the ordinary wall outlet and feeds this to the equipment under test (EUT). Any RF noise generated by the EUT is separated by the LISN and fed to the spectrum analyser for measurement or recording. MDL Technologies offer both CISPR & MIL-STD LISN Test Systems & Equipment for organisations across the UK.

Filter Products

Clear Filters
Products found: 15
  • 3625-2 LISN

    Frequency Range: 100 kHz – 65 MHz ETS-Lindgren Line Impedance Stabilization Networks (LISNs) are multi-line low pass filter networks used for...
    FIND OUT MORE
  • 3725-2M LISN

    Frequency Range: 10 kHz – 100 MHz ETS-Lindgren Line Impedance Stabilization Networks (LISNs) are multi-line low pass filter networks used for...
    FIND OUT MORE
  • 3810-2 LISN

    Frequency Range: 9 kHz – 30 MHz ETS-Lindgren Line Impedance Stabilization Networks (LISNs) are multi-line low pass filter networks used for...
    FIND OUT MORE
  • 3816-2 LISN

    Frequency Range: 9 kHz – 30 MHz ETS-Lindgren Line Impedance Stabilization Networks (LISNs) are multi-line low pass filter networks used for...
    FIND OUT MORE
  • 3850-2 LISN

    Frequency Range: 9 kHz – 100 MHz ETS-Lindgren Line Impedance Stabilization Networks (LISNs) are multi-line low pass filter networks used for...
    FIND OUT MORE
  • 4825-2 LISN

    Frequency Range: 9 kHz – 30 MHz ETS-Lindgren Line Impedance Stabilization Network (LISN) are multi-line low pass filter networks used for conducted...
    FIND OUT MORE
  • EMI Precompliance Receiver

    7010 Pre-compliance EMI Receiver

    PMM 7010 Series Pre-compliance EMI Reciever. All measurements performed by the 7010 are according to the most accepted standards like: IEC, CISPR, EN...
    FIND OUT MORE
  • Single Phase V-Network

    L1-150M1 100A Single Phase LISN

    The single-phase V-network PMM’s Artificial Mains Network L1-150M, with an equivalent circuit of 50 ohm // (1ohm + 5uH), meets the requirements...
    FIND OUT MORE

Product enquiry for

More InfoQuote